Cable Control Adjustment - IBEA IB 562 Manuel D'instructions

B) CABLE CONTROL ADJUSTMENT
To adjust the cables place the machine on flat ground, switch off the engine and disconnect
the wire from the spark plug.
B2) BLADE ROTOR CONTROL CABLE
The cable is controlled by the lever located on the handlebar as show Fig 5 Rif. D.
Operating the lever acts on both at the same time: the blade rotor mmoves, its brake
becomming disengaged.
For optimum regulation, follow the instructions, as described in sections C1 e D1.
B3) FORWARD CONTROL CABLE
BRAKE CONTROL CABLE
Both cables are controlled at the same time by the lever located on the handlebar.(Fig.5 Rif
A).
Operating the lever acts on both cables at the same time: the forward motion of the machine
is engaged and the parking brake disengaged.
For optimum regulation, follow the instructions, as described in sections C2 and D2.
Figure 5
A forward lever
B forward cable
C forward brake cable
D rotor engagement lever
E Rotor engagement cable
- 57 -