Hitachi CS 36DL Instructions De Sécurité Et Mode D'emploi page 6

English
g) If devices
connection of
collection facilities, ensure these are
connected and properly used.
Use of dust collection can reduce dust-
related hazards.
4) Power tool use and care
a) Do not force the power tool. Use the
correct power tool for your application.
The correct power tool will do the job
better and safer at the rate for which it was
designed.
b) Do not use the power tool if the switch
does not turn it on and off .
Any power tool that cannot be controlled
with the switch is dangerous and must be
repaired.
c) Disconnect the plug from the power
source and/or the battery pack from
the power tool before making any
adjustments, changing accessories, or
storing power tools.
Such preventive
reduce the risk of starting the power tool
accidentally.
d) Store idle power tools out of the reach
of children and do not allow persons
unfamiliar with the power tool or these
instructions to operate the power tool.
Power tools are dangerous in the hands of
untrained users.
e) Maintain power
misalignment or binding of moving
parts, breakage of parts and any other
condition that may aff ect the power
tool's operation.
If damaged, have the power tool repaired
before use.
Many accidents are caused by poorly
maintained power tools.
f) Keep cutting tools sharp and clean.
Properly maintained cutting tools with sharp
cutting edges are less likely to bind and are
easier to control.
g) Use the power tool, accessories and
tool bits etc. in accordance with these
instructions, taking into account the
working conditions and the work to be
performed.
Use of the power tool for operations diff erent
from those intended could result in a
hazardous situation.
5) Battery tool use and care
a) Recharge only
specifi ed by the manufacturer.
6
are provided for
dust extraction
safety measures
tools. Check
with the charger
the A charger that is suitable for one type of
and battery pack may create a risk of fi re when
used with another battery pack.
b) Use power tools only with specifi cally
designated battery packs.
Use of any other battery packs may create a
risk of injury and fi re.
c) When battery pack is not in use, keep
it away from other metal objects like
paper clips, coins, keys, nails, screws,
or other small metal objects, that can
make a connection from one terminal to
another.
Shorting the battery terminals together may
cause burns or a fi re.
d) Under abusive conditions, liquid may
be ejected from the battery; avoid
contact. If contact accidentally occurs,
fl ush with water. If liquid contacts eyes,
additionally seek medical help. Liquid
ejected from the battery may cause irritation
or burns.
6) Service
a) Have your power tool serviced by a
qualifi ed
identical replacement parts.
This will ensure that the safety of the power
tool is maintained.
–WARNING–
To reduce the risk of injury, user must read
for
instruction manual.
WARNING
Some dust created by power sanding, sawing,
grinding, drilling,
activities contains chemicals known to the State
of California to cause cancer, birth defects or
other reproductive harm. Some examples of
these chemicals are:
Lead from lead-based paints,
⦁
Crystalline silica from bricks and cement
⦁
and other masonry products, and
Arsenic and chromium from chemically-
⦁
treated lumber.
Your risk
depending on how often you do this type
of work. To reduce your exposure to these
chemicals: work in a well ventilated area, and
work with approved safety equipment, such as
those dust masks that are specially designed to
fi lter out microscopic particles.
repair person
and other
from these exposures
using only
construction
varies,