Assembly And Operation; Applications; Removal And Installation Method Of Battery; Charging Method - Hitachi CS 36DL Instructions De Sécurité Et Mode D'emploi

English

ASSEMBLY AND OPERATION

APPLICATIONS

○ Cutting of timber/logs
○ Pruning, felling of garden trees
REMOVAL AND INSTALLATION
METHOD OF BATTERY
○ How to install the battery.
Align the battery with the groove in tool handle
and slip it into place.
Always insert it all the way until it locks in place
with a click, If not, it may accidentally fall out
of the tool, causing injury to you or someone
around you (Fig. 1).
○ How to remove the battery.
Withdraw battery from the tool handle while
pressing the latch (2 pcs) of the battery (Fig. 1).
Handle

CHARGING METHOD

NOTE
Before plugging into the receptacle, make sure
the following points.
○ The power source voltage is stated on the
nameplate.
○ The cord is not damaged.
WARNING
Do not charge at voltage higher than
indicated on the nameplate.
If charged at voltage higher than indicated
on the nameplate, the charger will burn
out.
1. Insert the plug of battery charger into the
receptacle.
When the plug of battery charger has been
inserted into the receptacle, pilot lamp will blink
in red. (At 1-second intervals)
14
Latch
Pull out
Battery
Insert
Fig. 1
WARNING
Do not use the electrical cord
if damaged.
immediately.
2. Insert the battery to the battery charger.
Insert the battery into the battery charger as
shown in Fig. 2. Make sure it contacts until the
line is visible.
Battery
Pilot lamp
Before insert
After insert
3. Charging
○ When the battery is connected to the battery
charger, charging will commence and the pilot
lamp will light in red. (See Table 2)
NOTE
If the pilot lamp does not light or blink in red,
pull out the plug from the receptacle and check
if the battery is properly mounted.
○ When the battery is fully charged, the pilot lamp
will blink in red slowly. (At 1-second intervals)
(See Table 2)
Have it repaired
Line
Fig. 2