Hitachi CS 36DL Instructions De Sécurité Et Mode D'emploi page 15

Before
charging
While
The pilot
charging
lamp lights
or blinks in
Charging
red.
complete
Charging
impossible
The pilot
Overheat
lamp lights
standby
in green.
NOTE: When standby for cooling battery, UC36YRSL cools the overheated battery by cooling fan.
○ Regarding the temperature of the rechargeable
battery.
The temperatures for rechargeable batteries
are as shown in the table below, and batteries
that have become hot should be cooled for a
while before being recharged.
Table 3
Rechargeable
batteries
BSL3620
○ Regarding recharging time
Table 4 shows the recharging time required
according to the type of battery.
Table 4 Recharging time (approx. min.) at 20°C
Battery
Voltage
36 V BSL3620
NOTE
The recharging time may vary according to the
ambient temperature.
4. Disconnect battery
receptacle.
CAUTION
Do not pull the plug out of the receptacle
by pulling on the cord.
Make sure to
removing from
damaging cord.
Indications of the pilot lamp
Lights for 0.5 seconds. Does not light
Blinks for 0.5 seconds. (off for 0.5 seconds)
Lights continuously
Lights
Lights for 0.5 seconds. Does not light
Blinks for 0.5 seconds. (off for 0.5 seconds)
Lights for 0.1 seconds. Does not light
Flickers for 0.1 seconds. (off for 0.1 seconds)
Lights continuously
Lights
Temperatures at which the
battery can be recharged
32°F – 122°F (0°C – 50°C)
Battery capacity (Ah)
Li-ion BATTERY
2.0 Ah
60 min.
charger from
grasp the plug
receptacle to
Table 2
5. Remove the battery from the battery charger.
Supporting the battery charger with hand, pull
out the battery from the battery charger.
How to make the batteries perform longer.
○ Recharge the batteries before they become
completely exhausted.
When you feel that the power of the tool
becomes weaker, stop using the tool and
recharge its battery. If you continue to use
the tool and exhaust the electric current,
the battery may be damaged and its life will
become shorter.
○ Avoid recharging at high temperatures.
A rechargeable battery will be hot immediately
after use. If such a battery is recharged
immediately after use, its internal chemical
substance will deteriorate, and the battery
life will be shortened. Leave the battery and
recharge it after it has cooled for a while.
CAUTION
● When the
continuously used, the battery charger will
be heated, thus constituting the cause of
the failures. Once the charging has been
the
completed, give 15 minutes rest until the
next charging.
● If the battery is recharged when it is warm
due to battery use or exposure to sunlight,
the pilot lamp may light in green.
The battery will not be recharged. In such a
when
case, let the battery cool before charging.
avoid
English
Malfunction in the battery
or the charger
Battery overheated.
Unable to charge
(Charging will commence
when battery cools).
battery charger has been
15