Pre-Operation Inspection - Titan FastMelt 650 Mode D'emploi

PRE-OPERATION INSPECTION AND WARRANTY ACTIVATION
•
After the machine has been completely set up, the customer is to inspect the following. After each item is checked, email to
LIMAP@TITANTOOL.com to activate your warranty.

PRE-OPERATION INSPECTION

No parts of components on the machine have been damaged in shipment. Check for things such as dents and
loose, broken or missing parts. Correct or replace as required.
All bolts and fasteners are in place and tightly secured.
Bearings have been properly lubricated. See Lubrication information in this manual.
Engine started and is performing up to specs. All decals are in place and securely attached.
The Serial Number of your machine is recorded in the space provided on this page.
Test and run the unit while checking that all components are operating correctly.
Instruction manual and engine manual has been read.
I acknowledge that the procedures as outlined above were performed on this unit.
Print Name
Company Name
Phone
Equipment Model
Engine Model
Delivery Date
2
Signature
Date
Serial Number
Serial Number
Seller
FastMelt