Introduction - SciCan HYDRIM C51wd Mode D'emploi

1. Introduction

Thank you for selecting the Hydrim C51wd instrument washer-disinfector. The Hydrim
C51wd is designed in accordance with the EN15883-1 and -2, the European standards
for washer-disinfectors. The Hydrim complements the Statim and Quantim autoclaves by
quickly and hygienically preparing soiled instruments for sterilisation. To ensure years
of safe, trouble-free service, carefully review this Operator's Manual before operating the
unit. The Hydrim C51wd is suitable only for the applications listed in this manual. Using
the Hydrim for other purposes may be dangerous. The manufacturer cannot be held
responsible for damage caused by improper use.
Operational, maintenance and replacement instructions must be followed for the product
to perform as designed. All trademarks referred to in this manual are the property of their
respective owners. Contents of this manual are subject to change without notice to reflect
changes and improvements to the Hydrim product.
The Hydrim C51wd should only be installed and serviced by a qualified contractor as it is
an Installation Category 2 device. Before connecting the unit, the installer should check
that the voltage and frequency of the electrical supply correspond with the details in the
installation instructions. The unit must only be plugged into a grounded outlet. Please note
that this unit is completely isolated from the electrical supply only when it is unplugged or
the circuit breaker is turned OFF. This must be done before any repair work is carried out.
The Hydrim C51wd uses HIP™ Cleaning Solution exclusively. The unit will not perform
as described if other detergents / cleaning products are used. Other detergents / cleaning
products may damage the unit, the instruments, cause excessive foaming, and void
the warranty. Do not use solvents in this unit. Do not allow small children or unauthorised
personnel access to this unit or its controls.
HYDR IM C51wd Operator's Manual
Page 1