Initial Use; Setting The Device; What You Should Know About Using This Thermometer - Beurer FT 65 Mode D'emploi

4. Initial use

The batteries are already inserted in all new devices. Before first use, remove the protruding plastic insulating strip from the
battery compartment. The thermometer will then switch on automatically.
Further information and FAQs available at: http://www.beurer.com

5. Setting the device

Set the unit for the temperature display as well as the date and the time.
8 8 8
88:88
When the thermometer is used for the first time and each time the batteries are changed, the date and time are displayed (after
the self test) in the basic setting (
time. To set the device, proceed in stages: Unit – year – month – day – hours – minutes.
• Press the button for approx. three seconds in order to reach Set mode.
The setting to be changed will flash each time.
• Press the button again to save the setting or
• press the button to change the setting.
• Then press the button to save the setting.
After this process, the thermometer shows the word

6. What you should know about using this thermometer

There are different thermometers for taking temperature measurements in different parts of the body:
• Ear/forehead thermometer (this thermometer, for measuring in the ear or on the forehead area)
• Rod thermometer (for rectal [in the back passage], axillary [under the arm] or oral measurement [in the mouth])
24
Press the button for 1 second to switch the thermometer on. The device performs a brief
self test: all elements of the display are shown for approx. 1 second. Following a successful
self test, the device emits two short beeps. In Standby mode, the date and time are shown
8
and " " is displayed.
). Now set the unit in which the temperature will be displayed, the date and the
in the display and switches off automatically.