DT SWISS D 232 Manuel D'utilisation page 23

3.10 ATTACHING THE CABLE TO THE REMOTE LEVER
1. Screw in the cable adjuster (2) fully
and then turn it back out three
turns.
→ This achieves the greatest
adjustment range.
2. Use a 2 mm hex key to unscrew the
right clamping screw for the cable
on the remote lever by a few turns.
3. Push the cable through the cable
adjuster (2) and push the cable end
through the remote lever.
If you cannot push in the cable, unscrew the black cable adjuster (2) from the deflection tube (1) on
the remote lever and push the cable through the nylon liner first. Refit the cable adjuster with the
cable inserted.
4. Pull the cable tight and screw in the clamping screw to clamp the cable.
5. Trim off the protruding end of the cable and fit a cable end crimp on the cable.
6. Adjust the cable adjuster (2) until there is sufficient cable tension to remove play at the remote
lever.
3.11 ATTACHING THE CABLE TO THE L1 TRIGGER REMOTE LEVER
1. Screw in the cable adjuster (1) fully
and then turn it back out two turns.
→ This achieves the greatest
adjustment range.
2. Put a ferrule on the end of the
cable housing and insert the cable
housing into the cable adjuster (1) of
the remote lever.
3. Use a 2.5 mm hex key to unscrew
the clamping screw (2) for the cable
on the remote lever by a few turns.
4. Push the cable through the cable
adjuster (1) and push the cable end
through the remote lever.
5. Pull the cable tight and screw in the clamping screw (2) to clamp the cable.
6. Trim off the protruding end of the switch cable and fit a cable end crimp on the cable.
7. Adjust the cable adjuster (1) until there is sufficient cable tension to remove play at the remote
lever.
D 232 - User Manual V2021.03
1
1
2
2
23