DT SWISS D 232 Manuel D'utilisation page 17

3. ASSEMBLY
DANGER
Risk of accident caused by damage resulting from add-on parts with sharp edges!
Installing parts with sharp edges can damage the seat post.
• Make sure that the seat tube clamp, the seat tube of the bike frame, and any reduction shim
used do not have sharp edges.
3.1 ATTACHING THE REMOTE LEVER TO THE HANDLEBARS
1. Using a 3 mm hex key loosen the fixing screw
on the clamp and attach the remote lever on
the desired side of the handlebars.
2. Tighten the fixing screw with a max. tightening
torque of 1.5 Nm.
→ If the remote lever is fitted on carbon handlebars,
the maximum torque may be lower. Observe the handlebar
manufacturer's user manual!
3.2 ATTACHING THE L1 TRIGGER REMOTE LEVER TO THE HANDLEBARS
NOTICE: The L1 trigger is compatible with the
Matchmaker X interface.
1. Dismount the grip, open the screw of the
clamp slightly and slide the clamp onto the left
side of the handlebar.
2. Position the remote lever in such a way that the lever
can be comfortably reached with the thumb and neither
impairs its own function nor interferes with the function
of other control elements.
3. Tighten the fixing screw with a torque of max 1.5 Nm.
→ If the remote lever is fitted on carbon
handlebars, the maximum torque
may be lower. Observe the handlebar
manufacturer's user manual!
The position of the remote lever can be adjusted if
necessary.
4. Loosen screw (1).
5. Turn the remote lever to the desired position.
6. Tighten the screw (1) with a torque of 2 Nm.
D 232 - User Manual V2021.03
1
17