Installation - AYA ADV2S/2 Manuel D'utilisation

INSTALLATION

Installing the ceramic hob
The kitchen area should be dry and aired and equipped with efficient

ventilation. When installing the ceramic, easy access to all control
elements should be ensured.
This is a Y-type design built-in ceramic, which means that its back wall

and one side wall can be placed next to a high piece of furniture or a
wall .Coating or veneer used on fitted furniture must be applied with a
heat-resistant adhesive (100℃).This prevents surface deformation or
detachment the coating.
Hoods should be installed according to the manufacturer's instructions.

Assembly of ceramic hob :
Put a towel or cloth on the work

surface.Place the hob face down on the
protected surface.
Apply the strip seal, supplied with the

hob, which is for sealing it onto the work
surface.
Do not use silicone. Apply the seal to the
edge of the bottom of the hob, leaving
about 3mm from the edge of the glass.
Apply the seal all around the circumference.
Cut any excess and bring the two ends of
the seal together so they match.
Make an opening with the dimensions given in the diagram for the

hob to be mounted on the worktop．
Check seal for perfect fit and overall cover. Lower the electric hob into
place and align correctly.
Using a standard screwdriver, tighten the tension clamps evenly starting

at the centre and moving diagonal, until the built-in rim is tight on the
worktop.
EN-9