AYA ADV2S/2 Manuel D'utilisation page 47

Power level adjustment
Under t he st andby mode, p ress c ooking z one select button t o c hoose

the c orresponding cooking z one, c orresponding cooking zone d igital
tube decimal point " " and heating level will display. You can press the
plus " "and minus "
By holding down either of these buttons, the value on the zone

indicator will adjust up or down. Each pressing "
will a dd o ne, u ntil l evel 9, a nd di splayed o n its corresponding di gital
tube. Each pressing "
0(Each pressing o f "+" o r " -" b utton, a s hort a udible s ignal w ill b e
heard).Keep pressing "
increasing or decreasing effect.
Upon c ompletion o f p ower l evel a djustment, t he d ecimal p oint " "of

digital tube will stop flashing and normally display the power level within
10 seconds of no operation.
When switching any of the cooking zone power level to 0, it will stop the

power output of that cooking zone.
If a cooking zone has been heated,power level of all the cooking zone

are "0", the appliance will automatically enter into shutdown status
after 1 minute no operation.
Auto-heating function
Your hob can auto-heating following the below steps:
6.1 Turn on automatic heating :Press plus or mimus button to set the power to
level 9,then touch plus button "
" " and " ".At this time, press minus button"
level you need, such as level 6. In this automatic heating process, the
corresponding power level indicating digital tube is alternately display " "
and " ". Alternate display time is 2.5 minutes.
" buttons to adjust suitable power level.
" button, power level will reduce one, until level
", " " buttons will make continuously
" to let the power level alternately display
EN-14
" button, power level
" to adjust the auto-heating