AYA ADV2S/2 Manuel D'utilisation page 46

Under standby mode, if no any cooking zone heating operation, the

appliance w ill g o i nto s hutdown s tatus a utomatically a fter 1 0s a nd
beep once.
Heating control
Under standby mode, you can choose the cooking z one by pressing

the c ooking z one se lect b utton, t hen p ress plus o r m inus b utton o r to
adjust the power level of the corresponding c ooking z one. Press and
hold plus "
decrease the power level.
When the h ob t op i s i n heating st atus, p ress a nd h old "

button for 3s to switch off, and stop all the cooking zones to heat. The
corresponding cooking zone indicator of the hob top which has heated
before will display high temperature warning symbol " ".
Under st andby m ode, i f so me h ob t ops st ill e xist r esidual h eat, d isplay

will show " ".
If needing t o switch off o ne o f t he c ooking z ones, y ou can se lect t hat

zone f irst, then p ress t he m inus b utton "
switch o ff that z one, a nd w ill n ot affect the h eating o f t he o ther
cooking z ones. When p ower l evel reaches "0", t he corresponding
cooking z one i ndicator of t he h ob t op which h as h eated b efore w ill
display high temperature warning symbol " ".
If m ore t han o ne z one is operating at the s ame t ime, t otal p ower w ill

equal to the sum of the powers of all the working cooking zones, each
cooking zone will work according to their power modulation ratio, and
will not affect each other.
Note: 1. During the same period,only one hob top button is valid,that is

only one decimal point " " can be displayed.
2. Press minus button "

heating hob top will close automatically.
" or minus " " buttons can continuously to increase or
EN-13
" until "0" power l evel to
"to set the power level to "0",then the
" power