AYA ADV2S/2 Manuel D'utilisation page 49

For example, after entering the automatic heating mode, within 30 seconds
touch minus button "
indicating digital tube will display " " and " ". And then reduce to level 7,
the indicating digital tube will display " " and " ". At this moment,the hob
is still in the automatic heating mode. When more than 30 seconds, the level
7 can not be reduced to level 6, the automatic heating mode can be
exited, and the hob change to normal heating mode, the indicating digital
tube will display " ".
6.5 When changing the automatic heating level, the elapsed time will be
automatically calculated into the time corresponding to the new automatic
heating level.
For example, you have selected the automatic heating level to be level 1 (1
minute), and after 30 seconds you change the level to level 4 (6.5 minutes).
This automatic heating function will run accurately for 6 minutes (6.5 minutes
minus 30 seconds).
6.6 Within 30 seconds of automatic heating mode operation, press the minus
button " " to adjust to a certain level, then the running time is counted in
the set level time.
For example, when the indicating digital tube " " and " " is alternately
displayed and has been running for 20 seconds. Press the minus button "
to adjust to 6th level, then the 20 seconds that have been run will be
automatically counted in the 2.5 minutes of the 6th level, while the 6th level
will continue to run for 2.5 minutes minus 20 seconds, that is 2 minutes and 10
seconds. Then turn back to normal heating mode.
Shutdown timer
After selecting the corresponding power of the cooking zone, press the time
button" ", the timer digital tube will display "00" and the decimal point on
the right will display " ".
At this time, the timing mode is entered, and the timing time of the selected
burner can be set; (The following operations are required in In timing mode)
If you set the timing of two hobs at the same time, the timing remaining

time will be displayed alternately.
" to adjust auto-heating level to level 8. The
EN-16
"