AYA ADV2S/2 Manuel D'utilisation page 43

Cut a hole in the worktop that corresponds with the drawing shown above .
IMPORTANT: Y ou mu st o bserve t he v entilation r equirements s hown i n t he
drawing opposite.
IMPORTANT: There are ventilation holes around the outside of the hob. YOU
MUST ensure that these holes are not blocked by the work top, when you put
the hob into position (see drawing
opposite).
IMPORTANT: Do not use a silicon sealant to
seal the appliance against the aperture.
This will make it difficult to remove the hob
from the aperture in future, particularly if it
needs to be serviced
Carefully turn the hob back over

and then gently lower it into the
aperture hole that you have cut out.
There are holes on the base or the

sides of the hob that you can fix the four
brackets to.
You should place the bracket on the

underneath of the hob, in a position that
is a ppropriate f or t he a perture t hat y ou
have cut out. Using the screws provided, fix the bracket to the hob. These
screws MUST be securely tightened.
EN-10