Hob Guidelines - AYA ADV2S/2 Manuel D'utilisation

Power supply board relay
E3
failure
E4 1.Open circuit of the display
board NTC.
2.short circuit of the display
board NTC.
E5 High temperature protection
on the display board NTC.

HOB GUIDELINES

The first few times the hob top is used, it may give off an acrid, burning smell.
This smell will disappear completely with repeated use.
The worktop is fitted with cooking areas of different diameter and power.
The positions where the heat will radiate from are clearly marked on the hob
top. The sa ucepans must b e p ositioned e xactly o n t hese z ones f or e fficient
heating to occur. Pans should have the same diameter as the cooking zone
that they are being used on.
You sh ould n ot use sa ucepans w ith rough b ottoms, a s t his c an sc ratch t he
ceramic surface.
Before use, make sure that the bottoms of the saucepans are clean and dry.
When c old, t he b ottom o f t he p ans sh ould b e sl ightly c oncave, a s t hey
expand when h ot a nd l ie f lat o n t he s urface o f t he h ob. This w ill a llow t he
heat to transfer more easily.
The best thickness for the bottom of the pans is 2 – 3 mm of enameled steel
and 4 – 6 mm for stainless steel with sandwich type bottoms.
Replace the power supply
board.
Replace the display board
Replace the Insulated
silicone strip of circuit panel
first. If the fault persists,
replace the display board .
EN-20