Installation - AYA ATI3/2 Manuel D'utilisation

Heating stops suddenly
during operation and the
display flashes "u".
Heating zones of the
same side ( Such as the
first and the second
zone ) would display "u" .
Fan motor sounds
abnormal.
The above are the judgment and inspection of common
failures.
Please do not disassemble the unit by yourself to avoid any
dangers and damages to the induction hob.

9. Installation

9.1 Selection of installation equipment
Cut out the work surface according to the sizes shown in the
drawing.
For the purpose of installation and use, a minimum of 5 cm
space shall be preserved around the hole.
Be sure the thickness of the work surface is at least 30mm.
Please select heat-resistant and insulated work surface
material (Wood and similar fibrous or hygroscopic material
shall not be used as work surface material unless
impregnated) to avoid the electrical shock and larger
deformation caused by the heat radiation from the hotplate.
As shown below:
Pan Type is wrong.
Pot diameter is too
small.
Cooker has overheated;
The power board and
the display board
connected failure;
The display board of
communicate part is
damaged.
The Main board is
damaged.
The fan motor is
damaged.
60
Use the proper pot
(refer to the instruction
manual.)
Unit is overheated. Wait
for temperature to
return to normal.
Push "ON/OFF" button
to restart unit.
Check the connection.
Replace the display
board.
Replace the power
board.
Replace the fan.
Pan detection
circuit is damaged,
replace the power
board.