AYA ATI3/2 Manuel D'utilisation page 48

3.3 How to use
3.3.1 Start cooking
Touch the ON/OFF control for three seconds.
After power on, the buzzer beeps once, all
displays show "–" or "– –", indicating that the
induction hob has entered the state of
standby mode.
Place a suitable pan on the cooking zone
that you wish to use.
• Make sure the bottom of the pan and the
surface of the cooking zone are clean and
dry.
Touching the heating zone selection control,
and an indicator next to the key will flash
Select a heat setting by touching the "-" or
"+" control.
• If you don't choose a heat setting within 1
minute, the Induction hob will automatically
switch off. You will need to start again at
step 1.
• You can modify the heat setting at any
time during cooking.
If the display flashes
This means that:
• you have not placed a pan on the correct cooking zone or,
• the pan you're using is not suitable for induction cooking or,
• the pan is too small or not properly centered on the
cooking zone.
No heating takes place unless there is a suitable pan on the
cooking zone.
The display will automatically turn off after 1 minute if no
suitable pan is placed on it.
alternately with the heat setting
48