AYA ATI3/2 Manuel D'utilisation page 62

WARNING: Ensuring Adequate Ventilation
Make sure the induction cooker hob is well ventilated and
that air inlet and outlet are not blocked. In order to avoid
accidental touch with the overheating bottom of the hob, or
getting unexpectable electric shock during working, it is
necessary to put a wooden insert, fixed by screws, at a
minimum distance of 50mm from the bottom of the hob.
Follow the requirements below.
There are ventilation holes around outside of the hob.
YOU MUST ensure these holes are not blocked by the
worktop when you put the hob into position.
• Be aware that the glue that join the plastic or wooden
material to the furniture, has to resist to temperature
not below 150℃, to avoid the unstuck of the paneling.
• The rear wall, adjacent and surrounding surfaces must
therefore be able to withstand an temperature of 90˚C.
9.2 Before installing the hob, make sure that
• The work surface is square and level, and no structural
members interfere with space requirements.
• The work surface is made of a heat-resistant and
insulated material.
• If the hob is installed above an oven, the oven has a
built-in cooling fan.
• The installation will comply with all clearance requirements
and applicable standards and regulations.
• A suitable isolating switch providing full disconnection from
the mains power supply is incorporated in the permanent
wiring, mounted and positioned to comply with the local
wiring rules and regulations.
62