AYA ATI3/2 Manuel D'utilisation page 57

The touch controls are
difficult to operate.
The glass is being
scratched.
Some pans make crackling
or clicking noises.
The induction hob makes a
low humming noise when
used on a high heat setting.
Fan noise coming from
the induction hob.
Pans do not become hot
and appears in the display.
The induction hob or a
cooking zone has turned
itself off unexpectedly, a
tone sounds and an error
code is displayed (typically
alternating with one or two
digits in the cooking timer
display).
There may be a slight film of
water over the controls or
you may be using the tip of
your finger when touching
the controls.
Rough-edged cookware.
Unsuitable, abrasive scourer
or cleaning products being
used.
This may be caused by the
construction of your
cookware (layers of
different metals vibrating
differently).
This is caused by the
technology of induction
cooking.
A cooling fan built into your
induction hob has come on
to prevent the electronics
from overheating. It may
continue to run even after
you've turned the induction
hob off.
The induction hob cannot
detect the pan because it is
not suitable for induction
cooking.
The induction hob cannot
detect the pan because it is
too small for the cooking
zone or not properly centred
on it.
Technical fault.
57
Make sure the touch control
area is dry and use the ball
of your finger when
touching the controls.
Use cookware with flat and
smooth bases. See 'Choosing
the right cookware'.
See 'Care and cleaning'.
This is normal for cookware
and does not indicate a fault.
This is normal, but the noise
should quieten down or
disappear completely when
you decrease the heat setting.
This is normal and needs no
action. Do not switch the
power to the induction hob
off at the wall while the fan is
running.
Use cookware suitable for
induction cooking. See
section 'Choosing the right
cookware'.
Centre the pan and make
sure that its base matches
the size of the cooking zone.
Please note down the error
letters and numbers, switch
the power to the induction
hob off at the wall, and
contact a qualified technician.