Securing The Third Bicycle - EUFAB 1417 JAMES Manuel De L'opérateur

Table des Matières

Les langues disponibles

Now insert the link screws of the wheel rail with lighting into the rear drilled holes of the base frame extension element, Figure 2. Screw the wheel rail into

place firmly. The wheel rail of the extension is placed in the middle. Screw it into place with two wing nuts.

Wheel rail

with lighting

of extension

Figure 2: Position of wheel rails

5.2 LAYING THE ELECTRICAL CABLE

Lay the cables along the longitudinal carrier of the base frame. The cables may not be bent, stretched or crushed, e.g. in the vicinity of the folding

mechanism. Secure the cables with the supplied cable ties. When you are finished, trim any excess material from the cable ties using cutting pliers.

5.3 SECURING THE THIRD BICYCLE

The third bicycle is secured with the supplied frame holder reaching from Bicycle 2 to Bicycle 3. The loose, small tensioning strap is used to additionally

secure the front wheel, Figure 2.

Additional tensioning strap

Wrap the safety strap through the bicycle frames and the U-shaped bracket and tighten.

The frame holder may cause minor pressure points on the bicycle

frame and damages to the paintwork.

The bicycle rack may not be used without this safety strap.

5.4 SECURING THE TENSION-RELIEF STRAP

These instructions describe the use with estates and compact vehicles with a hatchback (rear door).

With boots (saloons) proceed appropriately.

Before mounting the tension-relief strap, remove dust and dirt from the upper region of the rear door

in order to prevent scratching and abrasion when travelling with the tow-bar rack.

Open the rear door of your vehicle. Guide the free end of the strap from the inside to the outside