Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2 x Wheel stopper
1 x Rail connector
1 x Connecting element with metal loop
2 x Washer,18 x 6 x 1
2 x Wing nut M6
2 x Tensioning strap, small
Place the two rail halves in front of you as shown on the pictures below, and guide the components in the sequence shown under the rail into the existing
link.
Left half
Right half
Pull one tensioning strap through a wheel stopper. Now insert one wheel stopper in each wheel rail into the top-
most link. Make sure that the wheel stopper can be pushed from the inside to the outside towards the wheel.
Connect the right and left halves of the rail with the rail connector.
Insert the connecting element from the top with the threaded bolt in the
drilled holes of the wheel rail. From below, insert the metal loop with the
ridges facing outwards, over the threaded bolt and screw firmly with two
washers 18 x 6 x 1 and two wing nuts.
Undo the wheel rail with lights on your bicycle rack. Remove the electrical cable by cutting the cable tie. Remove the plastic caps from the longitudinal
carriers of the base frame. Slide the base frame extension elements into place there and secure with the supplied Allen screws M6 x 15 and washers,
Figure 1.
Insert base frame extension
Figure 1: Insert the base frame extension element
Allen screws
12
Publicité
Table des Matières
