EUFAB 1417 JAMES Manuel De L'opérateur page 11

• Before embarking on any journey, check to make sure the straps used are undamaged and not worn.
• Damaged or worn straps must be replaced with undamaged ones before you embark on your journey. Only straps authorised by EAL
GmbH for the purpose may be used.
WARNING!
Personal injury or property damages caused by protruding parts.
Parts protruding beyond the edge of the vehicle or rack may cause personal injury or property damage during the journey.
• Only mount parts that do not protrude beyond the edge of the vehicle.
WARNING!
Personal injury or property damage due to tarpaulins.
Tarpaulins increase the air resistance. They may come undone and flap which may result in serious accidents. Do not use tarpaulins.
WARNING!
Personal injury or property damage due to loss of the bicycle rack.
The rack will only be seated properly on the coupling after it has been secured and driven for a few kilometres.
• After a few kilometres, check the secure seating of the rack.
• If it is seated loosely, reinstall. The quick closure may need to be adjusted. For this, see the relevant chapter of the bicycle rack operating
instructions. If there is no firm hold, the rack may not be used.
WARNING!
Personal injury or property damage due to breakage of the bicycle rack.
Driving with a mounted bicycle rack off the road may cause damages or breakage of the rack.
• Do not use the bicycle rack off the road.
• Only suitable for use on a car trailer coupling.
• Drive over speed bumps slowly: Maximum speed 10 km/h.
CAUTION!
Property damage due to opening tailgate.
The tailgate could hit the bicycle rack and be damaged.
• Switch off the electric tailgate and operate it manually.
• Fold down the bicycle rack before opening the tailgate.
CAUTION!
Property damage caused by hot exhaust gases.
Damages may be caused to the rack or bicycles if the exhaust outlet is close by.
• Use an exhaust deflector if necessary.
The general operating permit must be carried in the vehicle when the rack is mounted.
5. INSTRUCTIONS FOR USE
The extension element for the bicycle rack must first be assembled. Take all of the components out of the packaging and set them out clearly. Check the
scope of delivery. Every stage is described and clearly shows which components are required for the assembly of the rack.
5.1 ASSEMBLY OF THE 3RD WHEEL RAIL
2 x Wheel rail half
1 x Strap guide 2 x Link screw M6 x 75
11