Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Pre-Installation
VFSHW
Touch Panel
6500 Model
A
VFS
Flush Switch
6500 Model
A
Dometic
Flush Switch
4400 Model
A
3 Panel and Control Module Dimensions
A
Model
in .
mm
6500
3.0
77
4400
2.85
73
6
B
C
OK TO
FLUSH
DO NOT
FLUSH
B
C
B
C
Measurements
B
C
in .
mm
in .
3.5
89
0.4
1.85
47
.63
3 .3 .2 Minimum System Requirements
Dometic recommends that the toilet installation meet the
following minimum requirements:
Component
Electrical
Circuit breaker 2 A/12 VDC; 1 amp/24 VDC
Wiring
Water Supply
Fitting
Flow rate
Discharge
Fitting
I
Refer to ANSI 1192 and Z240 RV Series standards,
where applicable, for additional RV toilet
installation guidelines. Specifications are subject to
change without notice.
4 Pre-Installation
WARNING: SHOCK OR FIRE HAZARD .
Use the recommended fuse, circuit breaker, and
wire size. Failure to obey this warning could result
in death or serious injury.
This section has information on the preparation work
required prior to the toilet installation.
4 .1 Laying Out the Fresh-Water
mm
System
11
Figure 4 shows the recommended fresh-water system
16
layout for the gravity discharge toilets.
Use cold water only. Install a shut-off valve in the
I
water line for maintenance purposes.
Full Ceramic Gravity Discharge Toilet
Minimum Requirement
Marine: Refer to ABYC recommendations.
RV: Refer to ANSI/RVIA LV and NFPA 70/
NEC Standards (USA), or CEC I and II
Standards (Canada) for recommended wire
gauge sizes.
0.5 in. (13 mm) NPT
2.5 gpm/9.5 lpm minimum at toilet
4-bolt floor (closet) flange, 3.0 in. (77 mm)
ID, ABS or PVC connection to holding tank,
gravity drain
EN
Publicité
Chapitres
Table des Matières
