Intended Use; Specifications; Minimum System Requirements - Dometic 4000 Série Guide D'utilisation

3

INTENDED USE

The 4000 Series toilets are designed and intended for use only inside a boat or recreational
vehicle (hereinafter referred to as "RV") for which it is supplied . Use the instructions to ensure
correct installation of the toilet . Dometic Corporation accepts no liability for damage in the
following cases:
• Faulty assembly or connection .
• Damage to the product resulting from mechanical influences and excess voltage .
• Alterations to the product without expressed permission from Dometic Corporation .
• Use for purposes other than those described in the operating manual .
Dometic Corporation reserves the right to modify appearances and specifications without notice .
4

SPECIFICATIONS

4.1 Materials
Component
Toilet
Discharge fitting
4.2

Minimum system requirements

Electrical
Circuit breaker
Wiring
Water Supply
Fitting
Flow rate
Discharge
Inside diameter
Horizontal run
Vertical run
* The circuit board contains a resettable fuse that can be reset by turning the electrical power to
the toilet OFF, then ON again .
I
Refer to ANSI 1192 and Z240 RV Series standards, where applicable, for additional RV
toilet installation guidelines . Specifications are subject to change without notice .
5
4500, 4600, 4700, 4800
vitreous ceramic
polypropylene / PVC
4600, 4800
2 amps/12VDC; 1 amp/24 VDC*
Marine: Refer to ABYC recommendations .
RV: Refer to ANSI/RVIA LV and NFPA 70/NEC Standards
for recommended wire gauge (USA) . Refer to CEC I and II
Standards for recommended wire gauge (Canada) .
2 .0 gpm/7 .6 lpm minimum
1 .5" (38 mm) PVC pipe or sanitation hose
maximum 50' (15 m) from toilet to vacuum source
maximum 20' (6 . 1 m) from vacuum source to holding tank
maximum 6' (1 .8 m) from toilet to vacuum source
maximum 6' (1 .8 m) from vacuum source to holding tank
4500, 4700
1/2" NPT
2 .5 gpm/9 .5 lpm minimum
Toilets
EN