Dometic 4000 Série Guide D'utilisation page 15

➤ Lubricate the O-ring around the bottom of the toilet base using liquid dish-washing soap .
➤ Pick up the toilet and insert the plastic base assembly into the discharge adapter . Make sure
the mounting brackets on the floor do not interfere with the bottom of the toilet .
➤ Insert the two plastic flange bushings into the toilet mounting holes and secure the toilet to
the mounting brackets, using the two flat-head wood screws provided . Drive the fasteners
into the mounting brackets at a downward angle .
➤ Press the decorative screw covers over the flange bushings .
27
➤ Position the toilet over the floor brackets
and tilt it up from the back .
➤ Push the discharge-assembly fitting and
hose into the discharge-loop outlet .
➤ Tighten the band clamp .
➤ Lower the toilet back down to the floor .
➤ Turn on the water supply and electrical
power to the toilet .
➤ Check for leaks by pressing the flush
switch . If there is a leak, tighten the
connection .
29
Cover
Screw
Washer
4700 models only
➤ Drill pilot holes at the floor-mounting
holes .
➤ Install the screws and washers (provided)
using a 3/8" socket wrench .
➤ Place the plastic covers over the screws .
15
Mounting Brackets
28
Mounting
Bracket
Screw
Washer
Cover
(Rear View)
4500, 4600, 4800 models
➤ Insert the plastic washers from the
floor-bracket kit into the fastener holes .
➤ Fasten the toilet to the brackets using
the short screws included with the
floor-bracket kit .
➤ Place the plastic covers over the
floor-bracket screws .
Toilets
EN