General Information; Included Parts; Optional Parts - Dometic 4000 Série Guide D'utilisation

Toilets
fittings with two stainless steel, worm-drive, hose-band clamps at each connection .
Check connections frequently for integrity .
• Use properly positioned, ventilated loops when the potential exists for the toilet
rim to fall below the waterline during any heel, load, or trim condition, or when the
toilet is connected to any through-the hull fittings . The ventilated loops must be
installed in the intake (if connected to raw water) and/or the discharge piping .
• Ensure that all electrical power to the toilet is turned off and that seacocks are in the
closed or off position before installing the toilet or performing any maintenance .
• If the toilet uses fresh water for flushing and is connected directly or indirectly to a
shore side municipal water system at any time, shoreside water connections must
be discon nected if the boat is unattended (even if boat is unattended for a brief
period) .
• If the toilet is connected to any through-the-hull fittings, all flexible hoses must
be of marine sanitation quality and must be secured to any fittings (such as those
at seacock, vented loop or toilet) with two stainless steel, worm-drive hose band
clamps at each connection . Connections must be checked frequently for integrity .
• If the toilet uses raw water for flushing at any time, a raw-water pump controlled by
an automatically operat ing demand switch must not be installed . If the onboard
water valve or any plumbing connections were to leak, the automatically operated
pump would start and could flood the boat .
RISK OF PROPERTY DAMAGE . Failure to comply may cause damage to the toilet
or toilet system .
• Only flush water, bodily wastes, and rapid-dissolving toilet tissue .
• Do not overfill the holding tank, or serious damage can occur to the sanitation
system . Overfilling the holding tank can rupture the holding tank or release tank
contents into the bilge .
2

GENERAL INFORMATION

Included Parts

• Vacuum toilet
• Discharge adapter fittings

Optional Parts*

DTM01C tank monitor
DTM04 four-level tank monitor
*Available as accessory (not included)
I
A flush switch and vacuum source (purchased separately) are required . A status panel is
required for flush-handle models .
EN
• Floor-bracket hardware kit
• Floor-mounting template
4