General Safety Messages; General Information - Dometic MasterFlush 7600 Série Manuel D'installation Et D'utilisation

MasterFlush 7600 Series Toilet
• Read and understand these instructions before
installing,operating, or servicing this product.
• The installation must comply with all applicable local
or national codes, including the latest edition of the
following standards:
U .S .A .
– ANSI/NFPA70, National Electrical Code (NEC)
– ANSI/NFPA 1192, Recreational Vehicles Code
– ANSI Z21.57, Recreational Vehicles Code
Canada
– CSA C22.1, Parts l & ll, Canadian Electrical Code
– CSA Z240 RV Series, Recreational Vehicles

1 .4 General Safety Messages


WARNING: ELECTRICAL SHOCK, FIRE, AND/
OR EXPLOSION HAZARD . Failure to obey the
following warnings could result in death or
serious injury .
• Turn the power off before performing any electrical
installation or maintenance activities.
• Use care when diagnosing and/or adjusting
components on a powered unit.
• Use only Dometic replacement parts and
components that are specifically approved for use
with the appliance.
• Avoid improper installation, adjustment, alterations,
service, or maintenance of the appliance. Service and
maintenance must be done by a qualified service
person only.
• Do not modify this product in any way. Modification
can be extremely hazardous.
• Do not overfill the holding tank. To reduce this
possibility, use the full-tank shut-down circuitry in
the toilet's electronic control module. An optional
Dometic tank monitor system can generate a full-
tank signal and disable flushing until the holding
tank is emptied. Overfilling the holding tank can
cause serious damage to the sanitation system, such
as rupturing the holding tank and releasing tank
contents into the motorhome.
EN

2 General Information

This section provides information on the tooling and
parts for the MasterFlush
I The images used in this document are for reference
purposes only. Components and component
locations may vary according to specific product
models. Measurements may vary ±0.38 in. (10 mm).
Included Kits
Mounting Hardware Kit
(Floor Flange or Remote)
MasterFlush 7600 Series Toilet
Recommended Tools
Pliers or Adjustable Wrench
7/16 in. (11 mm) Wrench
Optional Parts
The MasterFlush 7600 Series toilet can be connected
to one of several Dometic holding tank monitoring
systems to offer accurate, continuous tracking of tank
capacity. Contact the Dometic Customer Support
Center or www.dometic.com
General Information
7600 Series toilet.
®
Quantity
1
1
Drill
Electrical Connection
Tools
for more information.
3