Installing The Toilet - Dometic MasterFlush 7600 Série Manuel D'installation Et D'utilisation

Installation
2. Disconnect and drain the water supply line.
3. Remove the toilet hold-down bolts and screws.
4. Remove the toilet from the floor.
5. Remove and dispose of the old floor flange seal, the
hold-down bolts, and any removal debris.

6 .3 Installing the Toilet

This section describes the two toilet installation options.
6 .3 .1 Floor Flange Installation
I To install the toilet farther from the holding tank,
skip to "Remote Installation" on page 9.
NOTICE: When lowering the toilet onto the floor flange,
the toilet must align so that the outlet at the base fits
inside the floor flange outlet hole.
NOTICE: The floor flange must be secured to the floor
with a minimum of four screws (eight is recommended).
Complete these steps to perform a floor flange toilet
installation:
1. Verify the top surface of the floor flange is clean and
free of any debris or sealant.
q
w
6 Installing the T-Bolts
T-Bolts
q
Slots
w
8
e
Floor Flange
e
2. Verify the new flange's toilet mounting holes are at
the correct location. See Figure 4 & Figure 6.
3. Secure the floor flange to the floor.
4. Insert the two T-bolts into the floor flange slots.
q
w
e
r
7 Installing the Floor Flange
Floor Flange Seal
q
Bolt Covers
w
Floor Mounting
e
Nuts and
Washers
5. Verify the floor flange seal is installed onto the base of
the toilet.
6. Carefully set the toilet over the floor flange.
7. Align the holes in the toilet base with the T-bolts as
the toilet is lowered onto the floor flange.
Do not rest the entire toilet base completely
I
on the floor at this time. The floor seal must be
compressed. Refer to the following steps.
MasterFlush 7600 Series Toilet
y
t
Floor Flange
r
Water Supply Connector
t
Black Rubber Elbow
y
EN