Initializing The Toilet System - Dometic 4000 Série Manuel D'utilisation

Toilets
3.6

Initializing the toilet system

➤ Turn on the water supply and electrical power to the toilet and other vacuum system
components .
➤ Flush water through the entire vacuum toilet system by flushing the toilet five times (press the
Flush handle or switch and allow each flush to complete until the green light indicates that
the system is ready for the next flush) .
I
Each cycle takes approximately one minute . If the toilet does not function as expected,
refer to "5 Troubleshooting" on page 9 for possible solutions .
3.7 Using the bidet (4800 models only)
 FLOOD HAZARD: Shut the bidet faucet off completely after use . Failure to do so
could result in property damage, serious injury, or death .
5
Handle
➤ Turn the handle away from the toilet to
activate the bidet faucet .
3.8 Using the bidet (4500 models only)
 FLOOD HAZARD: Shut the bidet faucet off completely after use . Failure to do so
could result in property damage, serious injury, or death .
7
Handle
➤ Turn the handle toward the front of the
toilet to activate the Wash function .
EN
6
Handle
➤ Adjust the water temperature by turning
the handle up for warm water, and down
for cool water .
➤ Use the electronic flush switch to clear
the toilet bowl during and after using the
bidet .
8
Handle
➤ Turn the handle toward the back of the
toilet to activate the Bidet function .
6