Initializing The Toilet System - Dometic 8000 Série Manuel D'utilisation

Toilets
3.3 Understanding the indicator lights for 8500, 8600, 8700, and 8900
Indicator
Power on
Tank level
*Flush actuation is disabled to prevent overfilling the holding tank
3.4 Changing the flush modes for 8500 8600, 8700, and 8900
Flush modes
Normal
Dry bowl
➤ To change modes, press the Flush switch or handle until the power-on light begins flashing
(about five seconds).
➤ Release the Flush switch or handle.
3.5 Toilet operation when connected to "full tank" shut-down relay and
tank monitor system (8100 models only)
When a macerator toilet system uses a "full tank" shut-down relay, flush capability is shut off when
the holding tank level reaches the "full" mark.
➤ Empty the holding tank to restore flush capability.
3.6

Initializing the toilet system

➤ Turn on the water supply and electrical power to the toilet.
➤ Press the Flush switch or handle once.
I
8100 models only:
➤ Press the Flush switch or handle and hold it for at least five seconds.
➤ Toss several sheets of toilet tissue into the bowl and flush the toilet again.
I
If the toilet does not function as expected, refer to "5 Troubleshooting" on page 10
for possible solutions.
EN
Light
Steady green
Flashing green
Amber
Red
Action
Adds water to the bowl after
every flush
Does not add water to the
bowl after every flush
Status
Electrical power to the toilet is
activated
Flush mode is changing
The holding tank is 75% full
The holding tank is 100% full*
Gallons per flush
0.85 gal (3200 ml)
0.45 gal (1700 ml)
6