Troubleshooting - Dometic 8000 Série Manuel D'utilisation

Toilets
5

TROUBLESHOOTING

Fault
The flush function works, but
the water in the bowl empties
slowly or not at all.
The macerator pump makes
an unusually loud noise or
repeatedly trips the circuit
breaker.
The toilet does not flush after
pushing the flush switch.
Not enough, or no water,
enters the bowl.
The water flow is weak during
bidet operation.
EN
Possible cause
The discharge pipe is pinched
or kinked.
The discharge head is
too high.
The macerator pump or the
discharge pipe is blocked.
There is foreign material in the
pump chamber.
The holding tank is full and a
signal from the tank has shut
down the electrical power to
the toilet.
Electrical power to the toilet is
shut off or disrupted.
The flush switch is
malfunctioning.
The circuit board in
the control module is
malfunctioning.
The water supply line is
pinched or kinked.
The screen in the water valve
is blocked.
The intake water filters
are blocked (in raw water
systems).
The water valve is
malfunctioning.
The inlet screen at the hot or
cold connection at the toilet/
bidet mixer valve is clogged.
The aerator in the bidet
nozzle inside the toilet bowl is
clogged.
The toilet/bidet mixer valve
assembly is not functioning
properly.
Suggested remedy
Straighten the discharge pipe
to remove the pinch or kink.
Reroute the discharge pipe.
Close the seacocks and clear
the blockage.
Close the seacocks and clear
the foreign material.
Empty the holding tank.
Check the wiring or circuit
breakers/fuses.
Replace the flush switch.
Replace the control module.
Straighten the water supply
line to remove the pinch or
kink.
Clear the blockage at the
water valve.
Clear the water filters.
Replace the water valve.
Disconnect the water lines
from the mixer valve and clean
the screen.
Remove and clean the aerator
nozzle.
Replace the mixer valve
assembly.
10