Understanding The Indicator Lights; Changing The Flush Modes; Initializing The Toilet System; Using The Manual Override Function - Dometic 4300 Manuel D'utilisation

General Information
5 6500 Series Bidet Function
2. Turn the handle toward the back of the toilet to
activate the Bidet function.
4 .4 Understanding the Indicator
Lights
I 6500 Series Only
This section explains the indicator lights for the 6500
series toilet control.
Indicator Light
Power on Steady green
Flashing green
Tank level Amber
Red
The flush actuation is disabled to prevent overfilling the
1
holding tank.

4 .5 Changing the Flush Modes

I 6500 Series Only
This section explains the flush modes available for the
6500 series toilets.
6
Status
Electrical power to the toilet
is activated
Flush mode is changing
Holding tank is 75% full
Holding tank is 100% full
1
Flush
Action
mode
Normal Adds water to the bowl after
every flush
Dry bowl Does not add water to the
bowl after every flush
1. To change modes, press the Flush switch or hold
the handle until the power-on light begins flashing
(about five seconds).
2. Release the Flush switch or handle.

4 .6 Initializing the Toilet System

Before the first use of the toilet system, or before each
use after an extended period of non-use, perform the
following procedure to get the toilet system ready for
operation:
1. Turn on the water supply and electrical power to the
toilet.
2. Flush the toilet once to confirm that the toilet
functions as expected.
3. Add holding tank deodorant or treatment into
the bowl and flush the toilet several times to add
additional water into the holding tank (follow the
deodorant manufacturer's directions).
4 .7 Using the Manual Override
Function
I 4300 and 4400 Series Only

CAUTION: FLOOD HAZARD .
Shut off the toilet system before performing any
service or maintenance tasks and do not leave
the vehicle for extended periods of time with the
toilet system circuit breaker on. Failure to obey this
caution could result in minor or moderate injury.
In the event of a power failure and emergency flushing is
required, to clean the toilet bowl or seals, or to perform
service or maintenance tasks that require keeping the
flush ball open without running water, use the manual
override feature.
1. Turn off the main power switch to the toilet.
Full Ceramic Gravity Discharge Toilet
Volume
per flush
1 qt
(0.95 L)
1 pt
(0.5 L)
EN