Using The Service Mode Function; Maintenance; Cleaning The Toilet; Setting An Inspection Schedule - Dometic 4300 Manuel D'utilisation

Full Ceramic Gravity Discharge Toilet
2. Open the small, round, plastic cover on the back
ledge of the toilet.
3. Insert a screwdriver or other thin blunt-end rod, and
push down on the manual override lever. This opens
the flush ball.
6 Manual Override Access
4. Perform the desired function.
5. Turn on the main power switch to the toilet.
The flush ball closes only after power is restored to
I
the toilet system.
4 .8 Using the Service Mode
Function
I 6500 Series Only
To clean the toilet bowl or seals, or to perform service
or maintenance tasks that require keeping the flush ball
open without running water, use the service switch.
1. Push and hold the service switch, located on the
control panel, for three seconds.
2. Perform the required tasks.
3. After the tasks are complete, push and hold the
service switch for three seconds to change the toilet
mode back to normal operation.

5 Maintenance

NOTICE: Do not use abrasive cleaners, caustic
chemicals, or lubricants and cleaners that contain
alcohols or petroleum distillates. Failure to obey this
notice may cause damage to the toilet's internal seals.
This section provides maintenance procedures
recommended to keep the toilet operating correctly.
EN

5 .1 Cleaning the Toilet

I Use non-abrasive cleaners to maintain the original
appearance of the toilet.
Follow this procedure to clean the toilet:
1. Add cleanser to the toilet bowl.
2. Clean the bowl by following the manufacturer's
instructions on the label of the cleanser.
3. Flush the toilet in normal mode to clear the bowl of
cleanser and debris.
4. Wipe down the toilet body using a damp cloth.

5 .2 Setting an Inspection Schedule

Set up a monthly and yearly inspection schedule to
ensure the toilet system is functioning properly. The
following table holds suggested inspection items to
include on your schedule.
Schedule Inspection Task
Monthly Inspect the toilet, plumbing, plumbing
connections, wiring, and wiring connections.
Open and close all of the plumbing
valves, including the seacocks (for marine
applications).
Check the inline water filters and the vented
loops for blockages.
Yearly Check the water valve inlet filter.
5 .3 Preparing the Toilet for an
Extended Period of Non-Use
Follow this procedure when not using the boat or RV for
an extended period of time:
1. Flush the toilet in normal mode.
2. Add 4 oz (120 ml) of liquid biodegradable laundry
detergent. The laundry detergent should not
contain bleach or other environmentally harmful
substances.
Maintenance
7