Installation - Dometic 4000 Série Guide D'utilisation

6

INSTALLATION

6.1 Installing the toilet with through-the-floor connections
10
Mounting
Template
➤ Place the floor-mounting template in
the desired location . Keep at least 11"
between the centerline of the template
and any walls or interior fixtures .
➤ Punch through the center of the holes and
mounting-bracket corners in the template .
I
4700 model toilets do not require
floor-mounting brackets .
I
Templates and hole configurations
vary by model .
12
Hex-Head Screw
Floor Bracket
4500, 4600, 4800 models only
➤ Secure the floor brackets to the floor using
the long hex-head screws from the toilet
floor-bracket kit .
➤ Loosely tighten with a 3/8" socket
wrench, using the mounting bracket
corner marks as guides .
I
Do not completely tighten the hex-
head screws to the floor . Brackets will
tighten when fastening the toilet to
the brackets .
9
11
➤ Remove the template from the floor .
➤ Drill all access and fastener holes as
indicated on the template, using the
center punches as guides .
I
4500, 4600, 4800 models
only: Do not drill mounting-bracket
corners .
➤ Repeat the steps under figure 12 and 13
using the wall switch template .
➤ Drill a 1" diameter hole .
13
Preferred Installation
Toilet
Base
Floor Flange
Floor
Sub-Floor
Elbow Fitting
I
The space between the bottom of
the toilet base and the bottom of the
floor flange rim should be no greater
than 3/8" .
Toilets
Hose
Adapter
EN