Routing The Power And Water Lines; Installing The "Full Tank" Shut-Down Relay And Tank Monitor System; Finalizing The Installation - Dometic 4300 Guide D'installation

Cuvette de toilette par gravité en céramique
Masquer les pouces Voir aussi pour 4300:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Full Ceramic Gravity Discharge Toilet
10 Floor Bracket Placement
1. Secure the floor brackets to the floor using the long
hex-head screws from the toilet floor-bracket kit.
2. Loosely tighten with a 3/8 in. (9.6 mm) socket
wrench, using the floor bracket corner marks as
guides.
I
Do not completely tighten the hex-head screws to
the floor. Brackets will tighten when securing the
toilet.
5 .4 Routing the Power and Water
Lines
This section explains how to route the power and water
lines for connection to the toilet.
11 Wiring and Water Line Placement
1. Route the DC power wiring and 0.5 in. (13 mm)
diameter water line through the drilled holes, as
applicable.
2. Place a shut-off valve in the water line to the toilet to
allow for easier maintenance or repair needs.
I
Refer to "4.2 Planning the Electrical Connections"
on page 7, and to the wiring diagram
provided with the toilet model's parts list. Wiring
configuration varies by model.
EN
5 .5 Installing the "Full Tank"
Shut-Down Relay and Tank Monitor
System
All installations can be set up to include the "full tank"
shut-down relay and tank monitor system options.
I
Consult the wiring diagrams included with the toilet
for further details. Wiring associated with these
options needs to be done prior to the next step.
1. Route the wiring for the "full tank" option per the
wiring diagram included with the toilet.
2. Proceed to "5.6 Finalizing the Installation" on page 9.

5 .6 Finalizing the Installation

This section provides the final connections, placement,
and fastening details for securing the toilet in place.
5 .6 .1 Connecting the Toilet Lines
This section explains how to connect the power and
water lines to the toilet.
q
e
w
12 Final Toilet Connection Points (6500 Series: Rear View)
Toilet
q
Water supply connection
w
Discharge assembly
e
1. Place the toilet near the access holes.
2. Connect the toilet water line to the water supply line.
3. Connect the touch panel or flush-switch panel wires
to the toilet wiring, as applicable.
Installation
t
r
Plastic base
r
Wiring
t
9

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

44006500

Table des Matières