Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installation
5 .6 .2 Placing the Toilet
This section describes how to place the toilet over the
discharge assembly before securing it to the floor.
1. Lubricate the O-ring around the bottom of the toilet
base, using liquid dish-washing soap.
2. Pick up the toilet and insert the plastic base into the
discharge assembly. Do not slide the toilet over the
assembly.
For the 6500 series: make sure the floor brackets
I
do not interfere with the bottom of the toilet.
3. Turn on the water supply and power to the toilet
controls, as applicable.
4. Check for leaks by flushing the toilet, filling it to the
appropriate level, and waiting for one hour to see if
the toilet leaks. See your applicable toilet operation
manual for details. If there is a leak, tighten the
connections.
5 .6 .3 Securing the 4300 and 4400 Series
Toilets
This section explains the final steps to secure the 4300
and 4400 series toilets. For information on securing the
6500 series toilets, refer to "5.6.4 Securing the 6500
Series Toilets" on page 10.
q
w
e
13 4300 and 4400 Series: Toilet Connection Points
Cover
q
Screw
w
1. Drill pilot holes at the floor-mounting holes.
10
Washer
e
Full Ceramic Gravity Discharge Toilet
2. Install the screws and washers (provided) using a
3/8 in. (9.6 mm) socket wrench.
3. Place the plastic covers over the screws
5 .6 .4 Securing the 6500 Series Toilets
This section explains the final steps to secure the 6500
series toilets. For information on securing the 4300 and
4400 series toilets, refer to "5.6.3 Securing the 4300
and 4400 Series Toilets" on page 10.
q
e
w
14 6500 Series: Toilet Connection Points
Cover
q
Screw
w
1. Insert the plastic washers from the floor-bracket kit
into the fastener holes.
2. Fasten the toilet to the floor-brackets using the short
screws included with the floor-bracket kit.
3. Place the plastic covers over the floor-bracket screws.
r
Washer
e
Floor Bracket
r
EN
Publicité
Chapitres
Table des Matières
