Adventys KTi1 4000 Guide D'utilisation Et D'installation page 37

Small problems and their remedies
If you think that your hob is not functioning correctly, this does not necessarily mean that a fault has
occurred. In any case, please check the following points:
You notice that
When switching it on, a bright display
appears
When switching it on, your
installation short-circuits
The ventilation continue a few minutes
after stopping the device
The device doesn't work. The display
on the casing stays off.
"F-" appears on the display
"F7" appears on the display
The device doesn't work, another code
appears on the display
After switching on the device, and
starting the cooking zone, the selected
indicator continues to flash
Pan makes noise while cooking
The device releases a smell during the
first cookings
If the vitroceramic hob suffers a breakage, split or crack, no matter how small, disconnect the
Possible causes
Regular functioning
The connection of your device is
defective
Cooling of the devise
The device is not supplied. The supply
or the connection is defective
There is a touch activated permanently
on the control keyboard
Electric circuits are over heating
Electric circuits doesn't work well
The pan you are using is not
compatible with the induction
technology or is of a diameter smaller
than 12 cm
It's a vibration generated by the
circulation of the current in the pan
New device
appliance immediately and contact After-Sales Service.
What you can do
Nothing: everything is normal
Verify your connection or the
conformity of the connection
It's normal
Inspect fuses and the circuit breaker of
your electric installation.
If the default doesn't' disappear, call
the after-sales service
Inspect the ventilation of the device
Call the after-sales service
See "Pans" section
This phenomenon is normal with some
type of pans. There is no danger.
Run the cooking during half an hour
with a pan full of water
37