Adventys KTi1 4000 Guide D'utilisation Et D'installation page 25

Product integration
4) Position the kit in the frame, then adjust the 4 screws so that the glass is flush with the worktop.
(We recommend that the position of the glass be equal or slightly lower than the worktop to avoid chip-
ping the glass when sliding a pan on the worktop.)
5) Remove the kit from the support.
6) Deposit thermal high-strength glue on the 4 supports.
7) Insert second time the kit inside the cut with better centering.
8) Press the kit until to touch the 4 screws.
9) Let the glue to get dry according to the recommendations of the glue manufacturer.
10) Make the seal (food quality) between the worktop and the ceramic glass.
11) Let dry according the recommendations of the seal manufacturer.
12) Remove glue/seal remnants on the worktop and the glass before starting up.
25