Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Product integration
Drop-in control panel (knob)
1) Realize a cut out of 215 x 88 mm minimum and 4 holes of diameter 7 mm minimum in your worktop.
To this end, follow the dimensions below :
2) Make a seal by creating a glue bead under your control panel (Novasil cartridge available as accesso-
ries).
3) Insert the control panel into the cut out.
4) Fix the control panel by tightening the bolts
27
Publicité
Table des Matières
