Adventys KTi1 4000 Guide D'utilisation Et D'installation page 31

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

How does your device work?
The principle of induction
After the appliance is switched on and a power level is
selected, electronic circuits produce induced currents in
the bottom of the containers which instantly transmits
the heat produced to the foodstuffs.
Cooking is carried out with practically no energy loss with
a very high energy output.
For the attention of people with
pacemakers and active implants
The functioning of the hob complies with the currently applicable norms concerning electromagnetic dis-
turbance. Your induction cooking hob therefore fully meets the legal requirements (89/336/CEE direc-
tives). It has been designed not to cause disturbance to other electric appliances insofar they also meet the
requirements of the same regulations.
Your induction hob emits magnetic fields in its immediate surrounding . To avoid the possibility
of interference between your cooking hob and a heart pacemaker, the latter must be designed to comply
with the regulations concerning it.
In this respect, we can therefore only guarantee the compliance of our own appliance. With regards to
compliance of a heart pacemaker or any eventual incompatibility, we recommend that you
consult its manufacturer or your doctor.
If a crack appears in the surface of the glass, disconnect the appliance immediately
from the mains supply to avoid the risk of electric shock. To do this, remove the fus-
es or operate the cut-off switch.
Do not use your appliance again until the vitroceramic glass has been replaced.
The device must not be used to store anything.
Ensure that the power cable of any electric appliance plugged into a socket near the unit is not in contact
with the cooking zones.
For cooking, never use sheets of aluminum foil or do not place products packed with aluminum or frozen
products in an aluminum tray directly on the device.
Aluminum will melt and permanently damage your device.
Do not clean your device with large amount of water.
Do not use a steam cleaner.
If the power cable is damaged, it had to be replaced by the manufacturer, the customer service or a person
with similar qualifications in order to avoid danger.
This device is not intended to be used by persons (including children) whose physical, sensory or mental ca-
pabilities are impaired, or persons without experience or knowledge, unless they have been able to benefit
though a person responsible for their safety, surveillance or prior instructions about the use of the device.
Be careful to objects worn by the user when using the device such as: rings, watches or similar objects
which can heat up if they are placed very close to the hob.
Only use containers of the type and size recommended.
All repairs should be performed by a qualified technician.
Make sure that the cladding and surrounding areas do not have metal surfaces.
Your induction hob is not intended to work with an external timer or with a separate remote control sys-
tem.
31

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Kti1 6000

Table des Matières