Maintenance And Diagnosis Of Failures; Maintenance; Failure Diagnosis - Erreka VIVO-M201 Manuel De L'installateur

MAINTENANCE AND DIAGNOSIS OF FAILURES

1

MAINTENANCE


Disconnect the device from the power supply before carrying out any maintenance operation.
1 Frequently check the installation in order to detect
any imbalance or sign of deterioration or wear. Do
not use the device if any repair or adjustment is
necessary.
2

FAILURE DIAGNOSIS

Diagnosis LEDs and fuses
P1 P2 P3
ST1
SW1 Main switch
F1 M1 Motor fuse
M201: 2.5A (230Vac/50Hz)
M201M: 6.3A (125Vac/60Hz)
F2 Electronic fuse
M201: 0.5A (230Vac/50Hz)
M201M: 1A (125Vac/60Hz)
F3 Output fuse 24Vac (315mA)
F4 M2 motor fuse
VIVO-M201: 2.5A (230Vac/50Hz)
VIVO-M201M: 6.3A (125Vac/60Hz)
DL1 - DL3 flashing: STOP contact open
(emergency stop activated)
DL1 Gate totally or partially open
38
Installation Manual
FCA2 COM FCC2 SCA
P4 P5 P6 P15 P14 P16 P7 P8
ST2 FT2 FCA1 FCC1 STOP
FT1
2 Check that the operation and safety devices
(photocells or strips), as well as their installation,
have not suffered any damage from the weather or
external agents.
G4
P11 P12 P22 P23 G7 G8 G9 G10
Courtesy
24Vac Lamp.
LOCK MOTOR2 (G2-G1-COM)
Light
DL2 Receiving RSD plug-in receiver radio signal
(RUN/OK)
DL3 Radio code or operation programming
DL4 Opening relay activated
DL5 Closing relay activated
DL6 Interior safety device contacts (FT2) closed
DL9 Exterior safety device contacts (FT1) closed
DL10 Pedestrian key command (ST2)
DL11 Total key command (ST1)
DL12 Plug-in receiver key command (except RSD)
DL13 Garage light relay activated
DL14 Power supply
DL15 Electrolock relay activated
DL17 Triac M1 activated
DL18 Triac M2 activated
G5 G6 G1 G2 G3
N L
POWER
MOTOR1 (G2-G1-COM)
E167D