Maintenance And Diagnosis Of Failures; Maintenance; Spare Parts; Failure Diagnosis - Erreka CLEVER02 Manuel De L'installateur

MAINTENANCE AND DIAGNOSIS OF FAILURES

1

MAINTENANCE


Disconnect the device from the power supply before carrying out any maintenance operation.
1 Frequently check the installation in order to detect
any imbalance or sign of deterioration or wear. Do
not use the device if any repair or adjustment is
necessary.
2

SPARE PARTS


If the device needs repairing, go to an
authorised assistance centre or manufacturer;
never try to repair it yourself.
3

FAILURE DIAGNOSIS

Diagnosis items
T.M. Operation time adjustment
LRN Radio code programming / receiving radio
code indicator
WTN Shutter gate open indicator
PWR Power supply indicator
OPN Opening relay enabled
CLS Closing relay enabled
ST1 Opening device (A.T.) indicator activated
ST2 Closing device (C.T.) indicator activated
34
Installation Guide
2 Check that the operation and safety devices

GND ANT
RECEIVER2
OPEN/CLOSE
TIME
PT1
PT2
F1
F2
SW1
(photocells or safety strips), as well as their
installation, have not suffered any damage from the
weather or external agents.
Use only original spare parts.
Opening safety device contacts (SG.A) closed
Closing safety device contacts (SG.C) closed
Main fuse (5x20):
CLEVER02: 2,5A (230V/ 50Hz);
CLEVER02M: 6,3A (125V/ 60Hz)
Electronic fuse (5x20): 500mA
Main switch