Connection To The Power Supply And Checking Of Turning Direction; Radio Code Programming (For Rsd Only) - Erreka VIVO-M201 Manuel De L'installateur

2

CONNECTION TO THE POWER SUPPLY AND CHECKING OF TURNING DIRECTION

1 Connect the main switch of the control board
(SW1).

The correct operation of the operators and of the
complete system will only be achieved after
programming. However, prior to programming, it is
necessary to carry out the checks listed below:
3

RADIO CODE PROGRAMMING (FOR RSD ONLY)

Using radio cards
This control board is factory set to use a two-channel
receiver (e.g. IRRE2). This factory setting is modified if
an RSD receiver is used and a permanent code is
recorded (decoding through the board, DIP1 + DIP4 or
DIP6 = ON).

When using the ERREKA RSD plug-in receiver (decoder-free receiver, trinary code), the radio code can be
programmed in the control board itself, as explained below. In other cases, follow the instructions of the plug-in
receiver used.
Total opening code programming
Pedestrian opening code programming
PROGRAMMING AND STARTUP
2 Check the turning direction of the operators using
mini-push buttons PUL1 and PUL2.

If the turning direction of any of the operators is
not correct, interchange the connection cables (G1
and G2) of the operator (for further details, see "Fig.
3 Power supply and operator connections" on
page 29).

Before carrying out any gate movement,
ensure there is no person or object in the radius
of action of the gate and the drive mechanisms.
To recover the factory settings, insert the IRRE2 card
and place DIP1 + DIP4 or DIP6 = ON. Then return the
DIPs to their previous position.
1 Connect the power supply of the control board
(SW1 in "ON").
2 Close the leaves by pressing PUL1.
3 Place DIP1 and DIP4 in "ON"; DIP2, DIP3 and DIP6 in
"OFF" (DL3 lights up statically).
4 Select the required code in the transmitter.
5 Press the channel to be used for total opening until
DL2 flashes on and off.
6 Place DIP1 and DIP4 in "OFF" (DL2 and DL3 go off).
1 Connect the power supply of the control board
(SW1 in "ON").
2 Close the leaves by pressing PUL1.
3 Place DIP1 and DIP6 in "ON"; DIP2, DIP3 and DIP4 in
"OFF" (DL3 lights up statically).
4 Select the required code in the transmitter.
5 Press the channel to be used for pedestrian opening
until DL2 flashes on and off.
6 Place DIP1 and DIP6 in "OFF" (DL2 and DL3 go off).
Control board VIVO-M201(M)
33