Electrical Connections - Erreka VIVO-M201 Manuel De L'installateur

4

ELECTRICAL CONNECTIONS


Complete the installation in line with low voltage regulations and applicable rules.

Use cables with sufficient section, always earthed (see "Elements of the complete installation (swing
gate)" on page 23.

Check the manufacturer's instructions for all the elements installed.
Power supply and operator connections
P1 P2 P3
ST1
FT1

When using a
operator, connect it to
cable connectors G1, G2
and G3 (operator A1).
A1, A2 operators
C1, C2 capacitors
DL4 open indicator
DL5 close indicator
PUL1 close mini-pushbutton
PUL2 open mini-pushbutton
T earth connection

When pressing PUL1 (close), DL5 lights up and the G2 and G3 and G5 and G6 cable connectors are activated.

When pressing PUL2 (open), DL4 lights up and the G1 and G3 and G4 and G6 cable connectors are activated.
Fig. 3 Power supply and operator connections
FCA2 COM FCC2 SCA
P7 P8
P4 P5 P6 P15 P14 P16 P11 P12 P22 P23 G7 G8
Courtesy
24Vac
STOP LOCK
ST2 FT2 FCA1 FCC1
Light
single
A1 operator connections
G1 open
G2 close
G3 common (COM), grey cable
G4 G5 G6 G1 G2 G3
G9 G10
N L
POWER
Lamp.
MOTOR2 (G2-G1-COM) MOTOR1 (G2-G1-COM)
G4 G5 G6 G1 G2 G3
A2 operator connections
G4
G5
G6
INSTALLATION
VIVO-M201: 230Vac/50Hz
VIVO-M201M: 125Vac/60Hz
P169V
open
close
common (COM), grey cable
Control board VIVO-M201(M)
29