Electrical Connections - Erreka CLEVER01 Manuel De L'installateur

4

ELECTRICAL CONNECTIONS

 Complete the installation in line with low voltage regulations and applicable rules.

Use cables with sufficient section, always earthed.

Check the manufacturer's instructions for all the elements installed.

Make the connections with the power supply cut off.

General connections
SW1
R.E.
CONNECTIONS:
ANT Cable connectors for antenna
R.E. Connector for plug-in receiver
A.T (ST1) Opening and closing key device
SG.C (FT1) Closing safety device
(photocell or mechanical strip)
AUX Output (24Vac, 350mA). Constant output in
order to feed peripheral devices
A Operator
C Operator capacitor
M Operator motor
FCA Operator opening limit switch
FCC Operator closing limit switch
Limit switches (FCA, FCC) of the operator
O
The shutter gate stops at the end of the operation
by way of the FCA and FCC limit switches built into
the operator. It is therefore necessary to always
have FCC and
accordingly.
ANT
T.E.
1 2 3 4 5
(1) ST1
(2) GND
350mA
(3) FT1
FCA and adjust them
INSTALLING AND PROGRAMMING
T.M.
J2
10 9 8 7 6
CONTROLS:
S1 Main switch
SW1 Radio code programming mini-pushbutton
RSD receiver (see "Radio code programming"
on page 26)
T.E Standby time regulation
(only functional in automatic mode)
Minimum value: 5 seconds;
maximum value: 140 seconds
T.M. Operation time adjustment
Minimum value: 1 second;
maximum value: 70 seconds
J2 Automatic/step-by-step closing mode switch
(see "Operation mode selection" on page 27)
Turning direction check
1 Connect the electrical power supply and press A.T.
(ST1). The first operation carried out after
connecting the power supply is opening.
2 If closing is to be carried out instead of opening,
interchange the cables connected to cable
connectors 9 and 10.
S1
CLEVER 01:
230Vac, 50Hz
CLEVER 01M:
125Vac, 60Hz
P166Z
CLEVER01 Control panel
25