Description Of The Product; Control Panel Features And Applications; Functioning Modes; Detection By Safety Device (Photocell Or Mechanical Strip) - Erreka CLEVER01 Manuel De L'installateur

DESCRIPTION OF THE PRODUCT

1

CONTROL PANEL FEATURES AND APPLICATIONS

CLEVER01 and CLEVER01M control panels are built to
form part of an automatic shutter gate system, driven
by way of a single phase motor with permanent
capacitor. The operator must have serially connected
limit switches (for example, tubular or centre shaft
operators).
It is necessary to install additional safety items
(photocells or strips) in order to fulfil the requirements
of Standard EN 12453.
2

FUNCTIONING MODES

Step-by-step mode (J2=SEMI)
Opening: this starts by briefly pressing the A.T. key
command (transmitter, magnetic key, key switch, etc).
If the key command is activated during opening, the
shutter gate comes to a stop. The shutter gate closes if
activated again.

The opening finishes when the time programmed by
T.M. finishes
Automatic mode (J2= AUTO)
Opening: this starts by briefly pressing the A.T. key
command (transmitter, magnetic key, key switch, etc).
If the key device is operated during opening, the shutter
gate stops and remains halted. Closing takes place
automatically once the programmed standby time has
passed. It can be closed in advance by running the key
device.

Opening finishes when the time programmed using
T.M. finishes
3

DETECTION BY SAFETY DEVICE (PHOTOCELL OR MECHANICAL STRIP)

Closing safety device (SG.C)
During opening: the closing safety device (SG.C.) does
not run in any case.
4

DECLARATION OF CONFORMITY

Erreka Automatismos declares that the CLEVER01/
CLEVER01M electromechanical operator has been
designed for use in a machine or for assembly along
with other elements in order to form a machine in line
with Directive 2006/42/EC.
Features
• Power supply:
CLEVER01: 230Vac, 50Hz; CLEVER01M: 125Vac, 60Hz
• Control of run by timing
• Adjustable standby time in automatic cycle
• Closing safety device cable connectors (photocells or
mechanical strips)
• Connector for plug-in receiver
• 24VAC cable connector for peripheral connection
Standby: the shutter gate remains open until an A.T.
key command is received.
Close: closing begins by briefly running the A.T. key
command (transmitter, magnetic key, key switch, etc).
If the key command is activated during closing, the
shutter gate comes to a stop. The shutter gate opens if
activated again.

Closing finishes when the time programmed by way
of T.M. finishes
Standby: the shutter gate remains open during the
programmed time. If A.T. is pressed briefly during
standby, the shutter gate closes.
Closing: closing begins automatically after standby.
If the key device is operated during closing, the shutter
gate stops and remains halted. Running the A.T. key
device again will open the shutter gate.

Closing finishes when the time programmed by way
of T.M. finishes
During closing: if the closing safety device (SG.C) is
activated during closing, the shutter gate inverts
operation direction and opens completely.
The CLEVER01/CLEVER01M control panels comply with
safety legislation, in line with the following directives
and regulations:
• 2006/95/CE (low voltage materials)
• 2004/108/EC (electromagnetic compatibility)
• EN 60555-2
English
23
CLEVER01 Control panel