Fortress Building Products PURE VIEW Instructions D'installation page 35

Fig. 5
STAIR BRACKET: POST MOUNTING
• Reference Post Mounting instructions on page 5.
Note:
IT'S RECOMMENDED TO INSTALL BRACKETS ON TO POST BEFORE
POST MOUNTING.
STAIR BRACKET: CUTTING DOWN TOP & BOTTOM RAILS
Step 1: Measure & Mark Rails Where Cuts Will Be Made
1. Position wood 2" x 4" [60mm x 101.5mm] on stairs in line
with bottom brackets.
2. Place bottom rail on top of wood 2" x 4" [60mm x 101.5mm]
next to bottom brackets.
3. Have bottom rail positioned as close to final installation
position as possible.
4. Add two balusters to the bottom rail, add top rail then clamp
panel to post. As shown in Fig. 1.
5. Measure spacing from inside edge of post to the baluster
space. Spacing CANNOT exceed 4"[101.5mm] on each end.
As shown in Fig. 2.
6. Place cut marking on rails in line with the back of bracket
opening. Be sure bottom of bracket and bottom of rail are
flush. As shown in Fig. 2.
7. Use speed square to ensure markings are perpendicular to
panel.
CB-05 Stair
Bracket
PURE VIEW: Fe GLASS BALUSTER INSTALLATION
26
Fig. 6
35