Fortress Building Products PURE VIEW Instructions D'installation page 10

Fig. 1
Measure the panel opening
Check measurement with top
UNIVERSAL BRACKET: CUTTING DOWN BOTTOM
Step 1: Measure & Mark Rails Where Cuts Will Be Made
1. To ensure rails are symmetrical, take the measurement
found on page 9, step 3 of Bracket Installation, and divide it
in half. Then cut equal lengths from both ends.
2. Find the center of the rails and measure out half of the
length each direction. As shown in Fig. 1.
3. Mark these locations with a pencil on the top and bottom
rail.
Fig. 1
Mark Here
Mark Here
Step 2: Cut & Clean Rails
1. Cut rails using a saw with a ferrous metal cutting blade.
2. Use file to smooth cut edges.
3. Remove any metal shavings and dust with a brush or rag.
4. Make sure surfaces to be painted are clean.
Note:
• Be sure not to cut Grommets in rails.
10
& TOP RAILS
Center of Rails
Half of Panel Length
PURE VIEW: Fe GLASS BALUSTER INSTALLATION
26
Fig. 2
Mark Here
Mark Here
Do not
measure from
post
Measure
from back
of bracket