Power Supply; Operation - geo-FENNEL GeoTape Mode D'emploi

POWER SUPPLY

CHARGE THE BATTERY
Push up the cover (9) of the USB port. Now the built-in
battery can be charged via USB connector.
When the charging process
is completed push the lock
down again.

OPERATION

LENGTH MEASUREMENT
Power on the unit with button (8), aim the laser dot at
the target selected and press button (1) short to carry
out a single measurement.
The value measured will be
shown in the lower display line.
With the next measurement
carried out the precedent value
will slip one line up.
AREA MEASUREMENT
Power on the unit with button (8) and press button (1)
long to activate the area measurement.
The area symbol will be displayed; the side to be
measured (i.e. length) will flash. Now aim the laser dot
at the first target selected and press the measuring
button (1). The first value measured (i.e. length) will be
displayed in the lower display line. Aim at the next tar-
get and press button (1) again to determine the second
value (i.e. width).The second side to be measured will
flash in the display.
With this second measurement the precedent value
will slip one line up . The second value measured will
be displayed shortly until the area and the circumfe-
rence will be displayed automatically.
EN
13