Displaying Stored Measurements - Beurer FT 95 Mode D'emploi

• If a connection to the app cannot be established after 30 seconds, the Bluetooth
goes out and the device switches off automatically after 60 seconds.
When connecting for the first time, a randomly-generated six-digit PIN code is displayed
on device, and at the same time an input field appears on the smartphone in which you
must enter this six-digit PIN code. After successfully entering the code, the device will
be connected to your smartphone (see also "Upload the measurements via Bluetooth
on page 51).

Displaying stored measurements

The device only stores measurements in forehead temperature mode
stores the values from the last 60 measurements.
When 60 memory spaces are exceeded, the oldest value is deleted.
• The memory can be called up as follows:
• With the thermometer switched on, press and hold the MODE/MEM button for 3 seconds.
The most recent measurement is displayed.
• Pressing the MODE/MEM button again will display the measured value.
• In the upper line, the time and date are displayed alternately.
50
® symbol
. The device automatically
® "